A feed pump for an auxiliary boiler might lose suction if the ______.

试卷相关题目

• 1A firebox explosion in an automatically fired auxiliary boiler may be the result of ______.

  A.excessive purging before lighting off

  B.insufficient trail for ignition period

  C.a faulty transformer in the ignition circuit

  D.insufficient purging after lighting off

  开始考试点击查看答案
• 2The water in a steaming auxiliary boiler should be tested daily for ______.

  A.dissolved oxygen

  B.chlorides

  C.sludge

  D.dissolved nitrogen

  开始考试点击查看答案
• 3______continuously extract the crankcase atmosphere, via a pipe system, and move it past a sensitive and accurate opacity (不透明)measuring track.

  A.The oil mist detectors

  B.The smoke detectors

  C.An oily water monitor

  D.Oil discharge monitoring and controlling system

  开始考试点击查看答案
• 4The maximum pressure developed by a waste heat boiler is determined by the main engine exhaust ______.

  A.gas composition

  B.gas temperature

  C.pressure

  D.timing

  开始考试点击查看答案
• 5A controllable pitch propeller on a diesel driven vessel eliminates the need for ______.

  A.friction clutches

  B.disconnect clutches

  C.reversing gears

  D.reduction gears

  开始考试点击查看答案
• 6The gear and screw pumps are classified as______.

  A.variable stroke pumps

  B.multistage pumps

  C.positive displacement pumps

  D.triple-ported pumps

  开始考试点击查看答案
• 7The pressure of a liquid leaving the pump can be referred to as the ______.

  A.total head

  B.discharge head

  C.net positive suction head

  D.suction head

  开始考试点击查看答案
• 8Which of the valves listed will be cycled from fully open to fully closed when the handle is turned 90 degree、

  A.A rising stem gate valve

  B.A globe stop valve

  C.A check valve

  D.A butterfly valve

  开始考试点击查看答案
• 9A pump shaft that is bent or distorted should normally be ______.

  A.repaired by a suitable welding process

  B.straightened by applying heat and torsion

  C.reconditioned by metallizing and machining

  D.replaced with a satisfactory spare

  开始考试点击查看答案
• 10A centrifugal pump may fail to deliver water when first started if the ______.

  A.water seal pipe is plugged

  B.pump is not primed

  C.seal ring is improperly located

  D.impeller is flooded

  开始考试点击查看答案